Hall Sensor Throttle Profile The hall sensor throttle has three wires, usually Red for +5VDC, Black for 0V/GND, and Green for throttle sensor output. Keep in mind, at minimum throttle the output ...

Sponsored by IDT: What’s the best sensor type to use for an accelerator pedal position system—resistive, magnetic, or inductive?

This month we are going to cover removing the carburetor air horn, removing the tamper-resistant plugs and adjusting the throttle position sensor (TPS).

Answer: We’ve seen the throttle-position sensor gum up and cause this problem. Pull it off the throttle body and inspect it. If there is any contamination or you find melted parts, replace it.

Holley's kit is simple to install, using a standard TPS sensor adapted to follow the primary throttle linkage movement, but this kit does require a carburetor using an electric choke.

Figure 2 Revised throttle position sensor In the revisions of Figure 2 , an opened return wire, either one, running from the low end of the throttle sensor to the car frame would be ohmmeter detected ...

Some Chevy Malibu owners may notice that their vehicle has reduced engine power. Now, a possible cause for this issue has been identified, plus a fix.

Operators of certain older 'Classic' Boeing 737 variants are being instructed to conduct tests to check for potential spoiler sensor failure, which could escape detection by the autothrottle ...

"One problem with the new engine was strange - the front-wheel speed sensor wire was damaged and shorting out, and that sent the engine management crazy, so that it would open the throttle mid ...

I have a 2015 Isuzu D-Max and the rpm won’t go higher than 2500. What could be the problem? I checked the throttle sensor, the fuel filter, everything. The first thought here is that you’re dealing ...

In the latest from his informational series, Jon Beekhuis, the NBCSN and ABC pit reporter and technical expert, explains the throttle fail-safes built into Verizon IndyCar Series cars with improved ...